HIKVISION DS-K1T642M - Access Control Settings

Unit No.
Set the device installed unit No.
Floor No.
Set the device installed oor No.
Door
Staon No.
Set the device installed oor No.
Note
If you change the No., you should reboot the device.
Community No.
Set the device installed community No.
If set the device type as Outer Door Staon, you can set the period No., outer door staon No.,
and community No.
Period No.
Set the device installed period No.
Outer Door
Staon No.
If you select outer door staon as the device type, you should enter a number between 1 and
99.
Note
If you change the No., you should reboot the device.
Community No.
Set the device installed community No.
8.5.19 Access Control
Sengs
Set Authencaon Parameters
Click Conguraon → Access Control → Authencaon Sengs .
Note
The funcons vary according to dierent models. Refers to the actual device for details.
Click Save to save the sengs aer the conguraon.
Device Type
Select Main Card Reader or Sub Card Reader from the drop-down list.
Face Recognion Terminal User Manual
84