HIKVISION DS-K1T642M - Chapter 8 Operation via Web Browser; 8.1 Login

7.5.2 Authencate via Mulple Credenal
Before You Start
Set the user
authencaon type before authencaon. For details, see Set Authencaon Mode .
Steps
1.
If the authencaon mode is Card and Face, Password and Face, Card and Password, Card and
Face and Fingerprint, authencate any credenal according to the instrucons on the live view
page.
Note
●
The card can be normal IC card, or encrypted card.
●
If the QR Code Scanning funcon is enabled, you can put the QR code in front of the device
camera to authencate via QR code.
●
The dimension of the recognized QR code picture should be larger than 6 cm × 6 cm.
2.
Aer the previous credenal is authencated, connue authencate other credenals.
Note
●
For detailed informaon about scanning ngerprint, see Tips for Scanning Fingerprint.
●
For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If authencaon succeeded, the prompt "Authencated" will pop up.
7.6 Basic
Sengs
You can set the shortcut key, voice, me, language, community No., building No., Unit No., and
beauty.
Long tap on the
inial page for 3 s and slide to the le/right by following the gesture and login the
device home page. Tap Basic.
Face Recognion Terminal User Manual
47