HIKVISION DS-K1T642M - Appendix C. Tips for Installation Environment; 1. Light Source Illumination Reference Value; 3. Avoid backlight, direct and indirect sunlight

Specify the seconds that the call with indoor staon will last for at most. The maximum
speaking duraon between indoor staon and the client can be set from 120s to 600s.
Max. Speaking Duraon with Door Staon
Specify the seconds that the call with door staon will last for at most. The maximum
speaking duraon between door staon and the client can be set from 90s to 120s.
Max. Speaking Duraon with Access Control Device
Specify the seconds that the call with access control device will last for at most. The
maximum speaking
duraon between access control device and the client can be set from
90s to 120s.
4.
Click Save.
9.12.5 Set File Saving Path
The pictures captured in Status Monitoring module are stored on the local PC. The saving path of
these les can be set.
Steps
1.
Open the System Conguraon page.
2.
Click File tab to enter the File Saving Path
Sengs page.
3.
Click and select a local path for the les.
4.
Click Save.
9.12.6 Set Email Parameters
When an event is triggered, if you can set Send Email as linkage acon for this event, the client will
an email to the recipients for
nocaon. You need to set the email sengs and specify target
recipients in this secon.
Steps
1.
Enter the System Conguraon module.
2.
Click Email tab to enter the Email
Sengs interface.
3.
Enter the required informaon.
STMP Server
The STMP server IP address of host name (e.g., smtp.263xmail.com)
Encrypon Type
You can check the radio to select Non-Encrypted, SSL, or STARTTLS .
Port
Enter the communicaon port used for SMTP. The port is 25 by default.
Sender Address
The email address of the sender.
Face Recognion Terminal User Manual
187