HIKVISION DS-K1T642M - 9.11 Time and Attendance

Steps
Note
The parameters congured here will be set as default for the newly added me period. It will not
aect the existed one(s).
1.
Enter Time & Aendance module.
2.
Click
Aendance Sengs → General Rule .
3.
Select the day(s) as weekend, such as Saturday and Sunday.
4.
Click Save.
Congure Overme Parameters
You can congure the overme parameters for workday and weekend, including overme level,
work hour rate, aendance status for overme, etc.
Steps
1.
Click Time &
Aendance → Aendance Sengs → Overme .
2.
Set required
informaon.
Overme
Level for Workday
When you work for a certain period aer end-work me on workday, you will reach dierent
overme level: overme level 1, overme level 2 and overme level 3. You can set dierent
work hour rate for three overme levels, respecvely.
Work Hour Rate
Work Hour Rate is used to calculate work hours by mulplying it by overme. When you work
for a certain period aer end-work me on workday, you will reach dierent overme level.
You can set
dierent work hour rates (1-10, can be a decimal) for three overme levels. For
example, your valid overme is one hour (in overme level 1), and the work hour rate of
overme level 1 is set as 2, then the work hours in the period will be calculated as 2 hours.
Overme Rule for Weekend
You can enable overme rule for weekend and set calculaon mode.
3.
Click Save.
Congure
Aendance Check Point
You can set the card reader(s) of the access control device as the aendance check point(s), so that
the authencaon on the card readers will be recorded for aendance.
Before You Start
●
You have added access control device(s). For details, refer to Add Device .
●
You have enabled T&A Status. For details, refer to
Add General Timetable .
Face Recognion Terminal User Manual
162