HIKVISION DS-K1T642M - Page 68

Figure 7-11 Access Control Parameters
The available parameters descripons are as follows:
Table 7-2 Access Control Parameters
Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
●
Only the device with the ngerprint module supports the
ngerprint related funcon.
●
Biometric recognion products are not completely applicable
to
an-spoong environments. If you require a higher
security level, use
mulple authencaon modes.
●
If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader
Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Face Recognion Terminal User Manual
52