HIKVISION DS-K1T642M - Page 91

Report Strategy Sengs
You can set the center group for uploading the log via the ISUP protocol.
Go to
Conguraon → Network → Basic Sengs → Report Strategy .
You can set the center group and the system will transfer logs via ISUP protocol. Click Save to save
the sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Advanced Sengs → Plaorm .
2.
Select ISUP from the
plaorm access mode drop-down list.
3.
Check Enable.
4.
Set the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5.
Click Save.
Plaorm
Access
Plaorm access provides you an opon to manage the devices via plaorm.
Steps
1.
Click Conguraon → Network → Advanced → Plaorm Access to enter the sengs page.
2.
Check the checkbox of Enable to enable the
funcon.
3.
Select the Plaorm Access Mode.
Face Recognion Terminal User Manual
75