HIKVISION DS-K1T805MBWX - 6.2 Authenticate via Multiple Credential

Chapter 6 Identy Authencaon
Aer network conguraon, system parameters conguraon and user conguraon, you can go
back to the
inial page for identy authencaon. The system will authencate person according
to the congured authencaon mode.
6.1 Authencate via Single Credenal
Set the user authencaon type before authencaon. For details, see Set Authencaon
Parameters .
Authencate ngerprint, or card.
Fingerprint
Place the enrolled
ngerprint on the ngerprint module and start authencaon via ngerprint.
Card
Present the card on the card presenng area and start authencaon via card.
Note
The card can be normal IC card, or encrypted card.
If authencaon completed, a prompt "Authencated" will pop up.
6.2
Authencate via Mulple Credenal
Before You Start
Set the user
authencaon type before authencaon. For details, see Set Authencaon
Parameters .
Steps
1.
Authencate any credenal according to the instrucons on the live view page.
Note
The card can be normal IC card, or encrypted card.
2.
Aer the previous credenal is authencated, connue authencate other credenals.
Note
For detailed informaon about scanning ngerprint, see Tips for Scanning Fingerprint.
If authencaon succeeded, the prompt "Authencated" will pop up.
Access Control Terminal User Manual
19