HIKVISION DS-K1T805MBWX - 8.6.10 Access Control Settings

If uncheck the funcon, you should set the IPv4 address, IPv4 subnet mask, IPv4 default
gateway, Mac address, and MTU.
If you check the funcon, the system will allocate the IPv4 address, IPv4 subnet mask, the IPv4
default gateway automacally.
DNS Server
Set the preferred DNS server and the Alternate DNS server according to your actual need.
Set Wi-Fi Parameters
Set the Wi-Fi parameters for device wireless connecon.
Steps
Note
The funcon should be supported by the device.
1.
Click Conguraon → Network → Network Sengs → Wi-Fi .
Figure 8-3 Wi-Fi Sengs Page
2.
Check Wi-Fi.
3.
Add Wi-Fi.
-
Click Manual Add, and enter SSID and Security Mode.
4.
Select a Wi-Fi
-
Click Connect of a Wi-Fi in the list and enter the Wi-Fi password.
-
Click Manual Add, and enter SSID and Security Mode. Click OK.
5.
Oponal: Set the WLAN parameters.
Access Control Terminal User Manual
28