HIKVISION DS-K2M0016A User Manual

Distributed Elevator Controller User Manual
4
Installation Chapter 3
Before your start:
 The minimum bearing weight of the wall or other places should be three times heavier than the device weight.
 Dial-up before you install. For details, see Section 2.3 DIP Switch Introduction.
3.1Installation without Case
Steps:
1. Drill holes on the wall or other places according to the holes on the guide rail.
2. Insert the screw sockets of the setscrews (supplied) in the drilled holes.
3. Secure the guide rail on the wall or other places with the screws (supplied).
4. Push the device to the guide rail and fix it.
3.2Installation with Case
Steps:
1. Drill holes on the wall or other places according to the holes on the case.
2. Insert the screw sockets of the set screws (supplied) in the drilled holes.
3. Secure the case on the wall or other places with the screws (supplied).

HIKVISION DS-K2M0016A Specifications

General

Brand	HIKVISION
Model	DS-K2M0016A
Category	Controller
Language	English