HIKVISION DS-KB8113-IME1 Series - Chapter 5 Remote C‰N‰〶‰‰‰‰Ti‰N Via Indoor ‰‰‰Ti‰N; Set up Door ‰‰‰Ti‰N Via Indoor ‰‰‰Ti‰N; Local ‰‰‰R‰Ti‰N

Chapter 5 Remote  via Indoor 
5.1 Set Up Door  via Indoor 
Steps
1.
Choose Language and tap Next.
2.
Set network parameters and tap Next
-
Edit Local IP, Subnet Mask and Gateway parameters.
-
Enable DHCP, the device will get network parameters 
3.
 the indoor 
1) Choose Indoor  Type.
2) Edit Floor and Room No.
3) Tap Next.
4.
Linked related devices and tap Next. If the device and the indoor  are in the same LAN,
the device will be displayed in the list. Tap the device or enter the serial No. to link.
1) Tap the door  in the list to link.
Note
If the door  is  the system will pop up the dialog to  the door 
2) Tap to pop up the Network  page.
3) Edit the network parameters of the door  manually or enable DHCP to get the network
parameters 
4)  Enable Synchronize Language to synchronize the language of door  with
indoor 
5) Tap OK to save the 
5.
Tap Finish to save the 
5.2 Local 
You can call the resident (the indoor  or the center (the master  via the door 
by pressing or holding the call  Default  of the call  when you press the call
 it calls the resident, and when you hold the call  it calls the center.
Before You Start
●
Make sure the door  has been 
●
Make sure the network cable is well-connected.
Steps
1.
Press the call  to call the resident.
2.
The resident can accept/decline the calling from the door  and unlock the door via the
indoor 
DS-KB8113-IME1(B) Series Vandal-Resistant Door  User Manual
15