HIKVISION DS-KB8113-IME1 Series - Chapter 6 Remote C‰N‰〶‰‰‰‰Ti‰N Via Mobile Client; Set up Mobile Client; Set up Door ‰‰‰Ti‰N Via Client

Chapter 6 Remote  via Mobile Client
6.1 Set Up Mobile Client
Before You Start
Make sure your mobile device has been connected to Wi-Fi.
Hik-Connect client is necessary for door   and 
Steps
1.
Install Hik-Connect client and register a user account for iOS and Android.
1) Search Hik-Connect in App Store or Google Play
TM
to download and install the client.
2) Launch the App and follow the on-screen  to register a user account.
2.
Start the Hik-Connect client, and login the client.
6.2 Set Up Door  via Client
To operate the door  normally, you should add the door  to the client.
Steps
1.
On the home page of the client, tap Add Device.
-
Scan QR code of the device to add.
Note
●
The QR code is printed on the label, which is on the rear panel of door  If you have
already installed the device, you can scan the QR code on the cloud service page in the
device.
●
Tap to enable the  if the scanning environment is too dark.
-
If there are device QR codes in photo album of the phone, tap
to extract QR code from
local album.
-
If the system fails to recognize the QR code, tap
and enter the serial No. to add the device
manually.
2.
Connect to the network.
1) Tap Next.
2) Connect the device to the router with a network cable.
Note
Make sure your mobile phone is connected to the same router.
3) Tap Connected.
3.
The account is connected to the device.
DS-KB8113-IME1(B) Series Vandal-Resistant Door  User Manual
17