HIKVISION DS-KB8113-IME1 Series - Page 5

Safety 
Warning
●
All the electronic  should be strictly compliance with the electrical safety 
   and other related  in your local region.
●
Please use the power adapter, which is provided by normal company. The power 
cannot be less than the required value.
●
Do not connect several devices to one power adapter as adapter overload may cause over-heat
or  hazard.
●
Please make sure that the power has been disconnected before you wire, install or dismantle the
device.
●
When the product is installed on wall or ceiling, the device shall be  
●
If smoke, odors or noise rise from the device, turn  the power at once and unplug the power
cable, and then please contact the service center.
●
If the product does not work properly, please contact your dealer or the nearest service center.
Never  to disassemble the device yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)

●
Do not drop the device or subject it to physical shock, and do not expose it to high
  Avoid the equipment  on  surface or places
subject to shock (ignorance can cause equipment damage).
●
Do not place the device in extremely hot (refer to the  of the device for the detailed
 temperature), cold, dusty or damp  and do not expose it to high
 
●
The device cover for indoor use shall be kept from rain and moisture.
●
Exposing the equipment to direct sun light, low  or heat source such as heater or
radiator is forbidden (ignorance can cause  danger).
●
Do not aim the device at the sun or extra bright places. A blooming or smear may occur
otherwise (which is not a  however), and  the endurance of sensor at the
same 
●
Please use the provided glove when open up the device cover, avoid direct contact with the
device cover, because the acidic sweat of the  may erode the surface  of the device
cover.
●
Please use a  and dry cloth when clean inside and outside surfaces of the device cover, do
not use alkaline detergents.
●
Please keep all wrappers  unpack them for future use. In case of any failure occurred, you
need to return the device to the factory with the original wrapper.  without the
original wrapper may result in damage on the device and lead to  costs.
DS-KB8113-IME1(B) Series Vandal-Resistant Door  User Manual
iv