HIKVISION DS-MCW407 Series - Safety Instructions; Laws, Power Supply, and Environment

Safety Instrucon
Laws and Regulaons
Use of the product must be in strict compliance with the local laws and regulaons. Please shut
down the device in prohibited area.
Power Supply
• Use of the product must be in strict compliance with the local electrical safety regulaons.
• Use the power adapter provided by qualied manufacturer. Refer to the product specicaon for
detailed power requirements.
• It is recommended to provide independent power adapter for each device as adapter overload
may cause
over-heang or a re hazard.
• Make sure that the power has been disconnected before you wire, install, or disassemble the
device.
• DO NOT directly touch exposed contacts and components once the device is powered up to
avoid electric shock.
• DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric
shock,
re hazard, and explosion.
• DO NOT directly cut the power supply to shut down the device. Please shut down the device
normally and then unplug the power cord to avoid data loss.
• DO NOT block the power supply equipment to plug and unplug conveniently.
• Make sure the power supply has been disconnected if the power adapter is idle.
• Make sure the device is connected to the ground
rmly.
Transportaon, Use, and Storage
• To avoid heat accumulaon, good venlaon is required for a proper operang environment.
• Store the device in dry,
well-venlated, corrosive-gas-free, no direct sunlight, and no heang
source environment.
• Avoid
re, water, and explosive environment when using the device.
• Avoid lightning strike for device installaon. Install a lightning arrester if necessary.
• Keep the device away from
magnec interference.
• Avoid device installaon on vibratory surface or places, and avoid equipment installaon on
vibratory surface or places subject to shock (ignorance may cause device damage).
• DO NOT touch the heat
dissipaon component to avoid burns.
• DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature
and humidity requirements, see device
specicaon.
• The device can only be safely used in the region below 2000 meters above the sea level.
Body Camera User Manual
vi