HIKVISION DS-PD2-P25-W User Manual

DS-PD2-T12P-WEL
12m Wireless Outdoor Detector
DS-PD2-P25-W
25m Wireless Long Range Corridor PIR Detector
Diagram References
E NGL ISH
For electrical products sold within the European
Community. At the end of the electrical products
life, it should not be disposed of with household
Check with your local Authority or retailer for
recycling advice in your country.
25m
8°
46 zones and 6 planes
0.3–3m/s
1.8-2.4m
Yes
Y
Yes
Yes
Front, rear, and bracket tamper signal input
Yes
433MHz, FM transceiver
800m
1x CR123A
2
125g
117 x 69 x 50mm
Yes
Yes
Blue Wave Technology
Signal Strength Indicators (SSI)
Transmission Frequency
Range in Open Space
Weight
Dimensions(H x W x D)
Ceiling mounted bracket includedy
Wall mounted bracket included
Environment Features
Accessories
Key Features
Technical Specification
Battery Information
2
1
3
4
A
B
C
CEILINGBRACKET
+
-
>5s
+
-
REGISTRATION
+
-
5s
+
-
LED ON LED OFF
LOW
HIGH
+
+
+
+
+
+
+
+
CR123A
LITHIUM
-
HIGH
LOW
TAMPER
=
=
REGISTRATION
BRACKET TAMPER
SEE SECTION4
A
B
EC
D
WALLBRACKET
REAR TAMPER
BREAK-OUT
Register Locally
Note: The distance between the security control panel and the detector
should be less than 50 cm.
Initialize the Detector
Register Via APP
Diagnostics(Check Signal Strength Before Mounting)
Wired Tamper and Brackets
Wireless device control
3
4
1
2
Registration
1. Log in to the APP Store and input” Hik-Connect” to search the mobile client.
Download and install Hik-Connect to your phone.
3. Power on the security control panel.
4. Log in the Hik-Connect and tap the icon”+” at the upper-right coner of the
Hik-Connect page to add the security control panel.You can scan the QR code
on the device rear panel or on the package box,or input the device serial No.
This product and - if applicable - the supplied accessories too are marked
with "CE" and comply therefore with theapplicable harmonized European
2011/65/EU.
8
UD09718B-A

HIKVISION DS-PD2-P25-W Specifications

General

Model	DS-PD2-P25-W
Category	Security Sensors
Detection Range	25 m
Detection Angle	90°
Power Supply	Battery
Battery Type	CR123A
Wireless Frequency	868 MHz
Protection Level	IP65
Type	Wireless PIR Detector
Operating Temperature	-10°C to 55°C
Humidity	Up to 95% (non-condensing)