30
7. Click OK.
Network Camera
You can add network cameras in the system.
Steps
1. Click Device → Network Camera to enter the network camera management page.
2. Click Enroll, and enter the basic information of the camera, such as IP address and port No., and
select the protocol type.
3. Enter the user name and password of the camera.
SADP Scanning
Scan all network cameras in the same LAN. A list will pop up after scanning. You can directly
check to add cameras in the list.
4. Click OK.
5. Optional: Click Edit or Delete to edit or delete the selected camera.
Module
Set module parameters.
Steps
1. Click Device → Module to enter the page.
2. Click edit the parameters.
3. Select linked areas.
4. Optional: Enable AUX according to your needs. It will enable the auxiliary power output of the
module. (Only for input expanders and output expanders.)
5. Click OK.
To Next Page
Loading...
Need help?
General
