7
8
Operation Caution and Device Maintenance
Specication
Replace Batteries
- All the electronic operation should be strictly compliance with the electrical safety regulations, re prevention regula-
tions and other related regulations in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid
the equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn o the power at once and unplug the power cable, and then please
contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism radiation. Avoid
the equipment installation on vibrations surface or places subject to shock (ignorance can cause equipment damage).
- Do not place the device in extremely hot (refer to the specication of the device for the detailed operation tempera-
ture), cold, dusty or damp locations, and do not expose it to high electromagnetic radiation.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (igno-
rance can cause re danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a
malfunction however), and aecting the endurance of sensor at the same time.
- Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type
only. Dispose of used batteries according to the instructions provided by the battery manufacturer.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situation.
4
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
The device is self powered from the manufacturer.
Replace all batteries at the same time.
Do not mix old and new batteries.
CAUTION
RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE
DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS
CHEMICAL BURNING DANGER
DO NOT SWALLOW THE BATTERY
KEEP NEW AND USED BATTERIES
AWAY FROM THE CHILDREN
INSTALL THE BATTERIES ACCORDING
TO THE POLARITY MARK ON THE
BATTERY HOLDER. THE OPPOSITE
POLARITY MAY CAUSE DEVICE
DAMAGE
DO NOT REVERSE THE POLARITY OF
THE BATTERY
Frequency 868 MHz
Metod Two-way communication
Distance 1.6 KM
Indicator Red/Green/Amber
Strobe light Red/Blue
Power Battery (default power supply method)
Consumption
Quiescent Current: 40uA
Max. 3 V/4A (alerts in volume level 3 )
Low Battery Cut O 2.45 V
Voltage Range Fully charged (new) to 2.45V DC (battery)
Battery life span
3 CR123A, 3 years in work status (triggered every two weeks and
alerting 90 s for each triggering)
Power switch Power switch
Tamper switch Front and rear tamper-proof
Decibel 90 to 110 db
Max. sound duration
15min
（900s）
Operation
Temperature
-10 °C to 40 °C (14 °F to 104 °F)
Operation Humidity 10% to 90%
Dimension (W × H ×
D)
88× 88 × 32 mm (3.46" ×3.46" × 1.26"）
Weight 169.5g
Installation Wall mounting
General
RF
Indication
Power
Interface
Buzzer
To Previous Page
Loading...
