81
require access but for only a short period (e.g., fire hydrant box's door or another external
security box door).
6. Enable Cross zone, Silent Alarm, etc. according to your actual needs.
Note
Some zones do not support the function. Refer to the actual zone to set the function.
Forbid Bypass on Arming
After enabled, you cannot bypass zones when arming.
Chime
Enable the doorbell. Usually used for door magnetic detectors.
Silent Alarm
After enabled, when an alarm is triggered, only the report will be uploaded and no sound is
emitted.
Double knock
After enabled, the time interval can be set. If the same detector is triggered twice or
continuously in a period of time, the alarm will be triggered.
7. Set the Sounder Delay Time. The sounder will be triggered immediately (0s) or after the set
time.
8. If required, link a PIRCAM or a camera for the zone.
9. Click OK.
Note
After adding the transmitter, you can click Device → Zone → Enroll to add a wired zone. Select
the Relate Mode as Wired, the Device Source as Single or Multi Transmitter, the Channel and
click OK.
After setting the zone, you can enter Maintenance → Device Status → Zone Status to view the
zone status.
10. Optional: Click Device → Zone and click Detector Settings. You can set detector parameters.
To Next Page
Loading...
Need help?
General
