HIKVISION DS-PT1-WE Manual

Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
6
Specificaon
5
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon
regulaons and other related regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then
please contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon.
Avoid the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment
damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon
temperature), cold, dusty or damp locaons, and do not expose it to high electromagnec radiaon.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden
(ignorance can cause fire danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not
a malfuncon however), and affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or
equivalent type only. Dispose of used baeries according to the instrucons provided by the baery manufactur-
er.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
4
Frequency
868 MHz
Metod Two-way communicaon
Distance 1.2 KM
Tamper Switch 1, rear panel tamper-proof
Indicator
1 status indicator(red, green, blue), and 4 area arming
indicator (blue)
Power Switch/ Learnt
Buon
1
Power Supply
1.5V, 3 AA baeries, 2 years baery life span (10 mes
presenng each day)
Operaon Humidity
10％ to 90％
Operaon Temperature
﹣10℃ to +55℃
Installaon Wall mounng
Weight 124mm x 75mm x 21mm
Dimension 176g (with baery), 106.5g(without baery)

HIKVISION DS-PT1-WE Specifications

General

Brand	HIKVISION
Model	DS-PT1-WE
Category	Card Reader
Language	English