DS-TMG033 Barrier Gate Radar User Manual
15
Chapter 3 Configuration
3.1 Install Software
Step 1 Double click setup.exe in the installation package, follow the prompts to finish installation.
After installation, a shortcut would be generated on desktop, as shown in figure 3-1.
Figure 3-1 Software Installation
Step 2 Run the ETGRadar icon to start the software, and the interface is shown as figure 3-2.
Configure
Radar parameters
目标出入状态显示区
Connect or disconnect
upper computer
Target access
displayed in animation
Target access condition
display area
Figure 3-2 Software Interface
Step 3 Connect devices.
1) Click Device Connect, a dialog box pops up as shown in figure 3-3.
To Next Page
Loading...
