Keep the device in original or similar packaging while
transporting it.
DO NOT drop the product or subject it to physical shock.
Power Supply
Refer to the device label for the standard power supply.
Please make sure your power supply matches with your
device.
Use a power adapter provided by qualified
manufacturers. It is recommended to provide an
independent power adapter for each device as adapter
overload may cause over-heating or a fire hazard.
Maintenance
If the product does not work properly, please contact
your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by
unauthorized repair or maintenance.
Cleaning
Please use a soft and dry cloth to clean the interior and
exterior surfaces. Do not use alkaline detergents.
Using Environment
When any laser equipment is in use, make sure that the
device lens is not exposed to the laser beam, or it may
burn out.
DO NOT aim the lens at the sun or any other bright light.
To avoid heat accumulation, good ventilation is required
for a proper operating environment.
DO NOT expose the device to extremely hot, cold, dusty,
corrosive, saline-alkali, or damp environments. For
temperature and humidity requirements, see device
specification.
DO NOT expose the device to high electromagnetic
radiation.
Emergency
If smoke, odor, or noise arises from the device,
immediately turn off the power, unplug the power cable,
and contact the service center.
To Next Page
Loading...
Need help?
General