Digital Video Recorder User Manual
199
Figure 15-9 User Permission Settings Interface
2) Set the operating permission of Local Configuration, Remote Configuration and Camera
Configuration for the user.
Local Configuration
Local Log Search: Searching and viewing logs and system information of device.
Local Parameters Settings: Configuring parameters, restoring factory default
parameters and importing/exporting configuration files.
Local Camera Management: Enabling and disabling analog camera (s). Adding,
deleting and editing of network camera (s). This function is supported by HDVR
series.
Local Advanced Operation: Operating HDD management (initializing HDD, setting
HDD property), upgrading system firmware.
Local Shutdown /Reboot: Shutting down or rebooting the device.
Remote Configuration
Remote Log Search: Remotely viewing logs that are saved on the device.
Remote Parameters Settings: Remotely configuring parameters, restoring factory
default parameters and importing/exporting configuration files.
Remote Camera Management: Remotely enabling and disabling analog camera (s),
and adding, deleting and editing of network camera (s). This function is supported by
HDVR series.
Remote Serial Port Control: Configuring settings for RS-485 port.
Remote Video Output Control: Sending remote control panel signal.
Two-way Audio: Realizing two-way radio between the remote client and the device.
Remote Alarm Control: Remotely arming (notify alarm and exception message to the
remote client) and controlling the alarm output.
To Next Page
Loading...
Need help?
General
