HIKVISION HWI-T220H

Network Turret Camera·Quick Start Guide
22
Note:
Drill the cable hole, when adopting ceiling outlet to route the cable.
Ø 130 mm (5.1")
Cable Hole
Figure 2-10 Drill Template
3. Disassemble the inclined base by the screw driver.
4. Install the mounting base of turret camera on the inclined base
cover with three PM4 screws.
Inclined Base
Cover
Mounting Base
Figure 2-11 Fix Mounting Base
5. Install the body of inclined base on the ceiling/wall with four PA4
× 25 screws.