iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 32
3. Click R/W Lock to set the reading and writing authority of the memory card.
1) Add a LockSelect the Lock Switch as ON.
2) Enter the password.
3) Click Save.
Unlock
• If you use the memory card on the camera that locks it, unlocking will be done automatically and no
unlocking procedures are required on the part of users.
• If you use the memory card (with a lock) on a different camera, you can go to HDD Management
interface to unlock the memory card manually. Select the memory card, and click the Unlock button
shown next to the Format button. Then enter the correct password to unlock it.
4. Remove the LockSelect the Lock Switch as OFF.
5. Enter the password in Password Settings.
6. Click Save.
Only admin user can set the R/W Lock.
The memory card can only be read and write when it is unlocked.
If the camera, which adds a lock to a memory card, is restored to the factory settings, you
can go to HDD Management interface to unlock the memory card.
7. Set Arming Schedule and Linkage Method. Refer to Set Arming Schedule and Linkage Method Settings
for details.
8. Click Save.
Set FTP
You can configure the FTP server to save images which are captured by events or a timed snapshot task.
Before You Start
Get the FTP server address first.
Steps
1. Go to Configuration → Network → Advanced Settings → FTP.
2. Configure FTP settings.
• FTP Protocol: FTP and SFTP are selectable. The files uploading is encrypted by using SFTP protocol.
• Server Address and Port: The FTP server address and corresponding port.
To Next Page
Loading...
Need help?
General
