HIKVISION iDS-2CD9856-BIS

Select it when the two network interfaces are connected to two network cables respecvely.
When one network interface fails, the other network interface will be employed
automacally without inuencing the data transmission.
Mul-Network Isolaon
Select it when dierent LANs are connected. Set the IP addresses of dierent network
segments.
Note
The dual-NIC mode varies with dierent models. The actual device prevails.
3.
Set network parameters.
NIC Type
Select a NIC (Network Interface Card) type according to your network
condion.
IPv4
Two modes are available.
DHCP
The device
automacally gets the IP parameters from the network if you check DHCP. The
device IP address is changed aer enabling the funcon. You can use SADP to get the device
IP address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Conguraon Protocol).
Manual
You can set the device IP parameters manually. Enter IPv4 Address, IPv4 Subnet Mask, and
IPv4 Default Gateway.
IPv6
Three IPv6 modes are available.
Route
Adversement
The IPv6 address is generated by combining the route adversement and the device Mac
address.
Note
Route adversement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Network Trac Camera Operaon Manual
32