Do not drop the dome or subject it to physical shock, and do not expose it to high
electromagnetism radiation. Avoid installation on vibrations surface or places subject
to shock (ignorance can cause equipment damage).
Do not touch senor modules with fingers. If cleaning is necessary, use clean cloth with
a bit of ethanol and wipe it gently. If the speed dome will not be used for an extended
period, replace the lens cap to protect the sensor from dirt.
Do not aim the speed dome at the sun or extra bright places. Blooming or smearing
may occur otherwise (which is not a malfunction), and affect the endurance of sensor
at the same time.
The sensor may be burned out by a laser beam, so when any laser equipment is in
using, make sure that the surface of sensor will not be exposed to the laser beam.
Do not place the speed dome in extremely hot, cold, dusty or damp locations, and do
not expose it to high electromagnetic radiation.
To avoid heat accumulation, good ventilation is required for operating environment.
Keep the speed dome away from liquid while in use.
While in delivery, the speed dome shall be packed in its original packing, or packing of
the same texture.
Improper use or replacement of the battery may result in hazard of explosion.
Replace with the same or equivalent type only. Dispose of used batteries according to
the instructions provided by the battery manufacturer.
L’utilisation ou le remplacement inadéquats de la pile peuvent entraîner un risque
d’explosion. Remplacez-la par le même type ou l’équivalent du même type seulement.
Jetez les piles usagées conformément aux directives fournies par le fabricant de la
pile.
To Next Page
Loading...
Need help?
General
