HIKVISION iDS-TCD403-BI - 10.7 Synchronize Time

10.7 Synchronize Time
Synchronize the device me when it is inconsistent with the actual me.
Steps
1.
Go to
Conguraon → System → System Sengs → Time Sengs .
2.
Select Time Zone.
3.
Select Sync Mode.
NTP
Synchronizaon
Select it to synchronize the device me with that of the NTP server. Set Server IP, NTP Port,
and Interval. Click NTP Test to test if the connecon between the device and the server is
normal.
Manual
Synchronizaon
Select it to synchronize the device me with that of the computer. Set me manually, or
check Sync. with computer me.
Satellite Time
Select it to synchronize the device me with that of the satellite. Set Interval.
SDK
If the remote host has been set for the device, select it to synchronize me via the remote
host.
ONVIF
Select it to synchronize
me via the third-party device.
PTP
Select it to synchronize me more accurately. Precision Time Protocol (PTP) is a protocol to
synchronize clocks in a computer network, similar to NTP. NTP is accurate, under ten
milliseconds. PTP, however, is accurate up to less than a microsecond and is measured in
nanoseconds.
No
Select it to disable
me synchronizaon.
All
Select it, and you can select any mode above.
Note
The me synchronizaon modes vary with dierent models. The actual device prevails.
4.
Click Save.
Network Trac Camera Operaon Manual
55