KB88113 Vandal-Resistant Video Intercom Doorbell User Manual
UM KB8113 Doorbell 021821NA 9
5.0 Remote Configuration via Indoor Station
5.1 Set Up Doorbell via Indoor Station
Choose Language and tap Next.
Set network parameters and tap Next.
• Edit Local IP, Subnet Mask, and Gateway parameters.
• Enable DHCP, the device will get network parameters automatically.
Configure the indoor station.
1) Choose Indoor Station Type.
2) Edit Floor and Room No.
3) Tap Next.
Linked related devices and tap Next. If the device and the indoor station are in the same LAN,
the device will be displayed in the list. Tap the device or enter the serial no. to link.
1) Tap the doorbell in the list to link.
If the doorbell is inactive, the system will pop up the dialog to activate the
doorbell.
2) Tap to pop up the Network Settings page.
3) Edit the network parameters of the doorbell manually or enable DHCP to get the network
parameters automatically.
4) (Optional): Enable Synchronize Language to synchronize the language of doorbell with
indoor station.
5) Tap OK to save the settings.
Tap Finish to save the settings.
5.2 Local Operation
You can call the resident (the indoor station) or the center (the master station) via the doorbell by
pressing or holding the call button. Default settings of the call button: when you press the call
button, it calls the resident, and when you hold the call button, it calls the center.
Before You Start
• Make sure the doorbell has been activated.
• Make sure the network cable is well-connected.
To Next Page
Loading...
Need help?
General
