KB88113 Vandal-Resistant Video Intercom Doorbell User Manual
UM KB8113 Doorbell 021821NA 11
6.0 Remote Configuration via Mobile Client
6.1 Set Up Mobile Client
Before You Start
Make sure your mobile device has been connected to Wi-Fi.
Hik-Connect client is necessary for doorbell configuration and operation.
Install Hik-Connect client and register a user account for iOS and Android.
1) Search Hik-Connect in App Store or Google Play
to download and install the client.
2) Launch the app and follow the on-screen instructions to register a user account.
Start the Hik-Connect client, and log in to the client.
6.2 Set Up Doorbell via Client
To operate the doorbell normally, add the doorbell to the client.
On the client home page, tap Add Device.
• Scan QR code of the device to add.
The QR code is printed on the label, which is on the rear panel of doorbell. If you
have already installed the device, you can scan the QR code on the cloud
service page in the device.
Tap to enable the flashlight if the scanning environment is too dark.
If there are device QR codes in photo album of the phone, tap to extract QR
code from local album.
If the system fails to recognize the QR code, tap and enter the serial no. to
add the device manually.
Connect to the network.
1) Tap Next.
2) Connect the device to the router with a network cable.
Make sure your mobile phone is connected to the same router.
3) Tap Connected.
The account is connected to the device.
To Next Page
Loading...
Need help?
General
