Figure 2-31 Install the Trim Ring Back
11. Turn the trim ring clockwise to secure the camera.
Figure 2-32 Secure the Camera
2.3.2 Installation with Junction Box/Inclined Ceiling
Mount
Before you start:
You need to purchase a junction box or inclined
ceiling mount in advance.
Ceiling mounting with junction box and inclined
ceiling mount are similar. Following steps take
junction box as an example.
Steps:
1. Paste the drill template for junction box to the place
where you want to install the camera.
2. (Optional) For cement wall, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
Figure 2-33 Drill Template
3. (Optional) Drill the cable hole, when the cables are
routed through the wall.
4. Turn the trim ring counterclockwise to remove it
from the camera.
Figure 2-34 Remove the Trim Ring
5. Take apart the junction box.
6. Fix the camera onto the junction box cover with
three PM4 × 10 screws.
To Next Page
Loading...
Need help?
General
