Network Dome Camera·Quick Start Guide
6 Operating via Hik-Connect App
Purpose:
Hik-Connect is an application for mobile devices. With the App, you
can view live image of the camera, receive alarm notification and so
on.
Note:
Hik-Connect service is not supported by certain camera models.
6.1 Enable Hik-Connect Service on Camera
Purpose:
Hik-Connect service should be enabled on your camera before using
the service.
You can enable the service through SADP software or web browser.
6.1.1 Enable Hik-Connect Service via SADP Software
Steps:
1. Check the checkbox of Enable Hik-Connect on:
1). "Activate the Device" page during camera activation, refer to
Chapter 4.2.2.
2). Or "Modify Network Parameters" page during modifying IP
address, refer to Chapter 4.3.
2. Create a verification code or change the verification code.
To Next Page
Loading...
Need help?
General
