6 English
▶ Close the cap over the dust removal hose connector for cutting metals.
Slits cut into load-bearing walls or other structures can influence the statics of the structure, especially when
reinforcing bars or load-bearing components are cut.
▶ Consult the responsible structural engineer, architect or person in charge of the building project before
starting work.
▶ Guide the power tool carefully and make straight cuts in order to keep the cutting disc from jamming. Do
not attempt to make curved cuts.
▶ Guide the power tool smoothly and do not apply lateral pressure to the cutting disc. Always bring the
power tool into contact with the workpiece at right angles. Do not attempt to change the line of cut by
applying lateral pressure or by bending the cutting disc while cutting is in progress. This could damage
the cutting disc and cause it to break.
▶ Never use the power tool without the guard.
3 Description
3.1 Product overview
DCH 300
Printed: 02.02.2018 | Doc-Nr: PUB / 5398464 / 000 / 00
To Next Page
Loading...
Need help?
General
