To Next PageTo Next Page
Need help?Do you have a question about the Hilti dx 2 and is the answer not in the manual?
General| Brand | Hilti |
|---|---|
| Model | dx 2 |
| Category | Power Tool |
| Language | English |
General safety information and specific points to observe.
Guidelines for using approved cartridges and their quality requirements.
Specifies that the tool is for professional use by trained personnel.
Advice on staying alert, common sense, and stopping if unwell during operation.
Explanation of danger, warning, caution, and note message types.
Defines warning and obligation signs used in the manual.
Specifies the intended professional applications and limitations of the tool.
Lists available fasteners by designation, application, and cartridge types.
Instructions for checking the tool's condition before operation.
Essential guidelines for fastening operations, including distances and spacing.
Specifies minimum edge and spacing distances for steel and concrete.
Details required fastener depth of penetration for steel and concrete.
Steps to follow when a cartridge does not fire or misfires.
Instructions on how to load nails and cartridges into the tool.
Guidance on selecting the appropriate power level for fastening.
Step-by-step process for driving a fastener correctly.
Procedure for cycling the tool to advance the cartridge strip.
Routine cleaning procedures for the exterior of the tool.
Regular checks and maintenance to ensure tool integrity and function.
When and how to service the tool for consistent performance.
Detailed steps for disassembling the tool for cleaning or repair.
Diagnoses and remedies when the tool fails to fire.
Troubleshooting steps for when the tool jams during operation.
Addressing misfires and partial fastener driving.
Solutions for when a cartridge fails to ignite.
Causes and remedies for cartridge strip melting.
Troubleshooting when cartridges detach from the strip.
Resolving issues with stuck pistons or over-driven fasteners.
Addressing fasteners that are not driven to the correct depth.
Solutions for bent nails, related to surface hardness or material.
Addressing concrete spalling during fastening.
Troubleshooting damaged nail heads.
Solutions for insufficient nail penetration.
Resolving issues with nails not securing properly in the base material.
Causes and remedies for nail breakage during fastening.
Addressing nails piercing through sheet metal.
Details on noise emission levels and measurement conditions.
Information on total vibration levels for the tool.
