Hilti DX 6 User Manual

DX 6
עברית 1
English 17

Hilti DX 6 Specifications

General

Brand	Hilti
Model	DX 6
Category	Power Tool
Language	English

Summary

Explanation of symbols used

Warnings

Alerts users to potential hazards, using signal words like DANGER, WARNING, CAUTION.

Product information

Safety

Safety instructions

General safety rules for handling the tool, using correct accessories, and basic maintenance.

Requirements to be met by users

Specifies user requirements, including training, proper PPE, and workplace safety.

Personal safety

Emphasizes personal safety, warning against misuse, pointing the tool, and operating while impaired.

Careful handling and use of fasteners

Guidance on safe use, checking for hazards like electrical wires, and proper handling of fasteners.

Intended use

Requirements to be met by cartridges

Technical data

Noise and vibration information

Details noise and vibration levels measured according to standards, and conditions for measurement.

Operation

Loading the single-fastener tool

Instructions for loading fasteners into a single-fastener tool.

Loading the magazine tool

Setting driving energy

Driving fasteners

Troubleshooting

WARNING Risk of explosion!

Warning about potential explosion hazard from cartridges if handled improperly.

WARNING Hazard due to hot surfaces!

Warning about hot surfaces on the tool during operation.

Fastening tool jams and does not extend

Troubleshooting steps for when the fastening tool jams or fails to extend.

Cartridge does not fire when fastening tool is hot

The cartridge does not fire when the fastening tool is at operating temperature

Care and maintenance

Maintenance

Servicing the tool

Disassembling the fastening tool

Checking piston and buffer

Problems with the fastening tool

The piston gets stuck in the base material

The fastener is not driven deep enough

Fastening tool cannot be fired

The piston jams in the fastener guide

Problems with fasteners

Different insertion depths

The component bends

The component does not enter flush

Problems with the cartridges

Cartridge strip is not OK

It is difficult to remove the cartridge strip

The cartridge does not fire

The cartridge strip melts