What to do if my Hilti SIW 6 AT-A22 Power Tool doesn’t work and the battery charge status display blinks?
If your Hilti Power Tool isn’t working and the battery charge status display is blinking, it could be due to a low battery or the battery being too hot or too cold. Try changing the battery and charging the empty one. Also, ensure the battery is at the recommended operating temperature.
Why is my Hilti Power Tool getting so hot?
If your Hilti Power Tool or its battery becomes very warm, it could be due to an electrical fault or overloading the tool. Immediately switch off the power tool, remove the battery, keep it under observation, and allow it to cool down. Also, ensure that you are using a suitable power tool for the application to avoid exceeding its limits.
Why does the running speed of my Hilti SIW 6 AT-A22 suddenly drop?
If the running speed of your Hilti Power Tool suddenly drops considerably, it's likely due to a low battery. Replace the battery with a fully charged one.
What does it mean when all four LEDs blink on my Hilti SIW 6 AT-A22 battery?
If your Hilti Power Tool doesn’t work and all four LEDs on the battery charge status display blink, it indicates that the power tool was briefly overloaded or the overheating cut-out has been activated. Release the control switch and then press it again. Also, allow the power tool to cool down and clean the air vents.
Why does the battery on my Hilti Power Tool drain so fast?
If the battery of your Hilti Power Tool runs down more quickly than usual, it may be due to very low ambient temperature. Allow the battery to warm up slowly to room temperature.
How to unlock the switch on a Hilti SIW 6 AT-A22?
If the control switch of your Hilti Power Tool can’t be pressed (i.e., the switch is locked), it's likely because the forward/reverse selector switch is in the middle position. Push the forward/reverse switch to the left or right to unlock it.
What to do if the battery doesn’t click into my Hilti Power Tool?
If the battery of your Hilti Power Tool doesn’t engage with an audible double click, it could be because the retaining lugs on the battery are dirty. Clean the retaining lugs and push the battery in until it engages.
General| Brand | Hilti |
|---|---|
| Model | SIW 6 AT-A22 |
| Category | Power Tool |
| Language | English |
Overview of the manual, safety instructions, and handling guidelines.
Details warning signals (Danger, Warning, Caution) and document symbols.
Explains symbols found on the tool itself, like Li-ion battery and NFC.
Covers tool usage by professionals and basic product information.
Comprehensive safety guidelines for work area, electrical, and personal safety.
Safety measures specific to drill/drivers.
Additional safety advice for screwdriver operations.
Identifies and labels all parts of the impact wrench and battery.
Defines the product's intended applications and limitations.
Details technical specifications like voltage, weight, speed, and bolt sizes.
Provides voltage, temperature, and charging specifications for the battery.
Steps before operating the tool, including charging, inserting, and removing the battery.
Instructions for attaching the optional belt hook and fitting accessory tools.
How to adjust torque settings on the tool.
Discusses different work modes and switch functions.
Specific guidance for screwdriving applications.
Guidelines for cleaning and maintaining the tool and its Li-ion batteries.
Information on regular checks, repairs, and using genuine spare parts.
Safety recommendations for transporting and storing the tool and batteries.
Lists common problems and their remedies for the power tool and battery.
Guidance on the proper disposal of batteries and electronic equipment.
Details on how to obtain information regarding the product's warranty.
To Next Page
