Why my Hilti Power Screwdriver doesn't run?
If your Hilti Power Screwdriver doesn't run, it might be due to the battery not being fully inserted. Ensure the battery is pushed in until you hear a distinct double click. Another possible cause is a low battery. Try changing the battery and charging the empty one.
What to do if running speed suddenly drops considerably on Hilti Power Screwdriver?
If the running speed of your Hilti Power Screwdriver suddenly drops considerably, the battery may be low. Try changing the battery and charging the depleted one.
Why Hilti Power Screwdriver or the battery becomes very warm?
If your Hilti Power Screwdriver or its battery becomes very warm, immediately switch off the power tool, remove the battery, keep it under observation, and allow it to cool down. This could be due to an electrical fault or because the tool is overloaded, exceeding its application limits. Consider selecting a more suitable power tool for the task.
How to unlock the control switch on Hilti Power Screwdriver?
If the control switch of your Hilti Power Screwdriver can’t be pressed because it's locked, the forward/reverse selector switch is likely in the middle position. Push the forward/reverse switch to the left or right to unlock it.
Why does the battery run down quickly on Hilti Power Screwdriver?
If the battery on your Hilti Power Screwdriver runs down more quickly than usual, it could be due to very low ambient temperature. Allow the battery to warm up slowly to room temperature.
What to do if the battery doesn’t engage with an audible double click on Hilti Power Screwdriver?
If the battery of your Hilti Power Screwdriver doesn’t engage with an audible double click, the retaining lugs on the battery might be dirty. Clean the retaining lugs and push the battery in until it engages. If the problem persists, contact Hilti Service.
General| Brand | Hilti |
|---|---|
| Model | SID 14-A |
| Category | Power Tool |
| Language | English |
To Next Page
