What to do if all 4 LEDs blink and Hilti Power Tool doesn’t run?
If all 4 LEDs are blinking and the power tool won’t run, it likely means the tool has been overloaded. To resolve this, release the on/off switch, then press it again. Allow the power tool to run under no load for approximately 30 seconds.
Why the saw blade cannot be inserted into the Hilti Power Tool?
If the saw blade cannot be inserted, the clamping system may be clogged with foreign matter. Clean out the blade holder.
How to fix the orbital action if it cannot be adjusted on Hilti Power Tool?
If the orbital action cannot be adjusted, there may be foreign matter in the orbital-action adjusting lever groove. Clean out the orbital-action adjusting lever groove.
What to do if all 4 LEDs blink and Hilti Tools don't work?
If all 4 LEDs are blinking and the power tool isn't working, it means the tool has been overloaded. Release the on/off switch, press it again, and let the power tool run under no load for about 30 seconds.
Why 1 LED blinks and Hilti Tools don't work?
If 1 LED is blinking and the power tool isn't working, it could be due to a discharged battery or the battery being too hot or too cold. Try changing the battery and charging the empty one. If that doesn't work, allow the battery to cool down or warm up slowly to room temperature.
Why does the battery run down quickly on Hilti Tools?
If the battery runs down more quickly than usual, it may be due to a very low ambient temperature. Allow the battery to warm up slowly to room temperature.
Why doesn’t the battery engage with an audible click in my Hilti SJD 6-A22?
If the battery doesn’t engage with an audible click, it's likely that the retaining lugs on the battery are dirty. Clean the retaining lugs and refit the battery.
What to do if 1 LED blinks and Hilti SJD 6-A22 Power Tool doesn’t run?
If only one LED is blinking and the power tool isn't running, it could be due to a low battery or the battery being too hot or too cold. Try changing the battery and charging the empty one. If that doesn't work, allow the battery to cool down or warm up slowly to room temperature.
What to do if the orbital action cannot be adjusted on Hilti Tools?
If the orbital action cannot be adjusted, there might be foreign matter in the orbital-action adjusting lever groove. Clean out the orbital-action adjusting lever groove.
How to fix Hilti Tools when the battery doesn’t engage with an audible click?
If the battery doesn’t engage with an audible click, the retaining lugs on the battery might be dirty. Clean the retaining lugs and refit the battery.
Essential safety advice and warnings for operating power tools, covering work area and personal safety.
Critical safety guidelines related to electrical connections, grounding, and usage in wet conditions.
Advice on staying alert, using protective equipment, and preventing unintentional starting.
Guidelines for proper usage, maintenance, and handling of the power tool to ensure safety.
Instructions for safe handling, charging, storage, and disposal of batteries.
Specific safety measures for operating reciprocating saws, including handling accessories.
Step-by-step guide on how to install a saw blade.
Steps for safely powering on the orbital-action jig saw.
Instructions for performing plunge cuts with the jig saw.
Procedure for safely powering off the orbital-action jig saw.
Instructions for safely releasing and ejecting the saw blade.
Safety precautions for transporting the tool and batteries, especially preventing accidental starting.
Diagnosing and resolving issues like the saw blade dropping out or not being insertable.
Addressing issues where orbital action does not work or cannot be adjusted.
Resolving issues related to battery performance, engagement, and charge indicators.
General| Battery Voltage | 21.6 V |
|---|---|
| Weight | 3.8 kg |
| Chuck Type | T-Shank |
| Battery Type | Li-ion |
| Max. torque | 50 Nm |
To Next Page
