18
7. Operation
3. Adjust the height of the tool until the beam is at the
correct position.
4. Mount the cable trays along the laser line.
7.2.3 Example 3:
Installing pipes vertically on a wall
1. Set up the tool on a level surface in front of
the wall.
2. Switch on the vertical beam.
3. Pivot the tool until the laser line projected on the
wall is at the position where the vertical pipe is
to be installed.
4. Install the pipe along the laser line.
7.2.4 Example 4:
Tiling a wall
1. Set up the tool on a telescopic pole or tripod.
2. Switch on the horizontal and vertical beams.
3. Adjust the position of the tool until the beams are at
the desired position.
4. Lay the tiles along the laser lines.
To Next Page
Loading...
Need help?
General
