Why doesn't my Hilti Laser Level tool work?
Your Hilti Laser Level might not be working because: * The battery is not fully inserted. Push the battery in until you hear it click. * The battery is discharged. Replace the discharged battery with a charged one.
What to do if the Hilti Laser Level battery doesn’t engage with an audible click?
If the battery doesn’t engage with an audible click, the retaining lugs on the battery may be dirty. Clean the retaining lugs and refit the battery.
What to do if my Hilti Laser Level tool gets very hot?
If your Hilti Laser Level tool or battery gets very hot, it may be due to an electrical fault. Immediately switch off the tool, remove the battery, keep it under observation, allow it to cool down and contact Hilti Service.
Why does my Hilti Laser Level battery run down quickly?
If the battery in your Hilti Laser Level is running down more quickly than usual, it could be due to a very low ambient temperature. Warm up the battery slowly to room temperature.
What to do if my Hilti PR 2-HS A12 Measuring Instruments tool or battery gets very hot?
If your Hilti Measuring Instruments tool or battery gets very hot, immediately switch off the tool and remove the battery. Keep the battery under observation, allow it to cool down, and then contact Hilti Service due to a potential electrical fault.
General| Brand | Hilti |
|---|---|
| Model | PR 2-HS A12 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
