*2184702*
2184702 English 9
Status Meaning
4 LEDs blink, the power tool is not
ready for use.
The power tool is overloaded or has
overheated.
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch. If
the battery display LEDs blink, please observe the instructions given in
the Troubleshooting section.
3.4 Items supplied
Drill / driver, operating instructions.
• Other system products approved for use with this product can be found
at your local Hilti Store or at: www.hilti.group
4 Technical data
4.1 Drill/driver
Rated voltage
21.6 V
Weight including battery B22⁄8.0
6.8 lb
Speed 1st gear
0 /min …
370 /min
2nd gear
0 /min …
2,140 /min
Torque (soft joint)
≤ 37 ftlb
f
Torque range (15 settings)
1 ftlb
f
… 9 ftlb
f
Ø drill bit (metal)
1/16 in … 1/2 in
Ø drill bit (hardwood)
1/16 in … 3/4 in
Ø drill bit (softwood)
1/16 in …
1 1/4 in
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
To Next Page
Loading...
