6 English 2130487
*2130487*
3 Description
3.1 Overview of the product 1
@
Side handle
;
Keyless chuck
=
Torque and drilling mode selector ring
%
Gear selector switch
&
Forward/reverse switch with switch-on inter-
lock
(
Control switch (with electronic speed control)
)
Grip
+
Light to illuminate the work area
§
Belt hook (optional)
/
Liion battery
:
Battery release button
∙
State of charge and fault display (Li-ion bat-
tery)
3.2 Intended use
The product described is a hand-held cordless drill/driver. It is designed for driving and removing screws
and for drilling in steel, wood and plastic.
• Use only Hilti lithiumion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If theaccessorytool sticks or stalls, the product will suddenly pivot about its own axis in the oppositedirection.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.4 Liion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Liion battery. The charge status of the Liion battery is displayed after pressing one of the two battery
release buttons.
Status Meaning
4 LEDs light. Charge status: 75 % to 100 %
3 LEDs light. Charge status: 50 % to 75 %
2 LEDs light. Charge status: 25 % to 50 %
1 LED lights. Charge status: 10 % to 25 %
1 LED blinks, the power tool is ready for use. Charge status: < 10 %
1 LED blinks, the power tool is not ready for use. The battery has overheated or is completely dis-
charged.
4 LEDs blink, the power tool is not ready for use. The power tool is overloaded or has overheated.
To Next Page
Loading...
Need help?
General
