What to do if my Hilti Drill doesn’t work and all four LEDs blink?
If your Hilti Drill isn’t working and all four LEDs are blinking, it could be due to a brief overload. Try releasing the control switch and then pressing it again. Another possibility is that the overheating cut-out has been activated. In this case, allow the drill to cool down and clean the air vents.
How to troubleshoot a Hilti SF 22-A Drill that doesn't run?
If your Hilti Drill doesn't run, ensure the battery is fully inserted. If that's not the issue, the battery might be discharged, so try charging it.
Why Hilti SF 22-A Drill doesn't run?
Your Hilti Drill might not be running because the battery isn't fully inserted. Ensure you insert the battery correctly. Alternatively, the battery may be discharged, so try charging it.
Why is one LED flashing on my Hilti Drill and it doesn't work?
If your Hilti Drill isn’t working and one LED is flashing, it could mean the battery is discharged. Try charging the battery. It could also indicate that the battery is too hot or too cold. Allow the battery to reach the recommended operating temperature.
Why does the Hilti Drill battery run down quickly?
If your Hilti Drill battery is draining faster than usual, it may be due to a very low ambient temperature. Allow the battery to warm up slowly to room temperature.
How to fix no hammering action on Hilti SF 22-A Drill?
If you're not getting any hammering action from your Hilti Drill, the operating mode might not be set correctly on the selector ring. Set the power tool to “hammer drilling.”
How to unlock the on/off button on a Hilti SF 22-A?
If the on/off button on your Hilti Drill can’t be pressed, and the button is locked, the forward/reverse selector switch is likely in the middle position. Set the forward/reverse switch to the desired position to unlock it.
What to do if the Hilti SF 22-A Drill battery doesn’t engage with a click?
If the Hilti Drill battery doesn’t engage with an audible double click, the retaining lugs on the battery might be dirty. Clean the retaining lugs and push the battery in until it engages.
What to do if Hilti SF 22-A doesn't work and one LED flashes?
If your Hilti Drill doesn't work and one LED flashes, it could be due to a discharged battery, in which case you should charge it. Alternatively, the battery might be too hot or too cold. If so, bring the battery to the recommended operating temperature.
What to do if Hilti SF 22-A Drill doesn’t work and all four LEDs blink?
If your Hilti Drill doesn’t work and all four LEDs blink, it may have been briefly overloaded. Release the control switch and then press it again. Alternatively, the overheating cut-out may have been activated. In this case, allow the power tool to cool down and clean the air vents.
General| Voltage | 22 V |
|---|---|
| Weight | 1.8 kg |
| Chuck Type | Keyless |
| Speed Settings | 2 |
| Battery Type | Li-ion |
| Chuck size | 13 mm |
| Number of gears | 2 |
| Battery voltage | 22 V |
To Next Page
