12 English 2073070
*2073070*
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Selecting the gear 4
▶ Select the gear.
6.2 Setting forward or reverse rotation 5
▶ Set the forward/reverse switch to the desired direction of rotation.
▶ An interlock prevents switching while the motor is running. In the middle
position the switch is locked (safety lock).
6.3 Switching on
▶ Press the control switch.
▶ Speed can be controlled steplessly right up to maximum by varying
how far the control switch is pressed in.
6.4 Screwdriving
1. Set the function selector ring to the required torque setting.
2. Set the forward/reverse switch to the desired direction of rotation.
6.5 Drilling
1.
Set the function selector ring to the symbol.
2. Set the forward/reverse switch to the “forward” position.
6.6 Drilling with hammering action (hammer drilling)
1.
Set the function selector ring to the symbol.
2. Set the forward/reverse switch to the “forward” position.
6.7 Switching off
▶ Release the control switch.
6.8 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
To Next Page
Loading...
Need help?
General
