How to fix a Hilti SF 8M-A22 that does not work?
If your Hilti Drill isn't working, first ensure the battery is fully inserted until you hear a double click. If that doesn't solve the issue, the battery may be discharged. Try changing the battery and charging the empty one.
Why is my Hilti Drill getting so hot?
If your Hilti Drill or its battery gets very hot, it could be due to an electrical fault or because the product is overloaded. Immediately switch off the drill, remove the battery, keep it under observation, and allow it to cool down. Also, ensure you are not exceeding the product's application limits by checking its suitability for the task at hand in the “Technical data” section.
What to do if my Hilti SF 8M-A22 Drill does not work and all four LEDs flash?
If your Hilti Drill isn't working and all four LEDs are flashing, it could be momentarily overloaded or the overheating cut-out has been activated. Try releasing the control switch and then pressing it again. If that doesn't work, allow the product to cool down and clean the air vents.
Why is one LED flashing on my Hilti SF 8M-A22 and it does not work?
If your Hilti Drill isn't working and one LED is flashing, the battery is either discharged or too hot/cold. Try changing the battery and charging the empty one. If that doesn't work, bring the battery to the recommended operating temperature.
What to do if the battery does not engage with my Hilti SF 8M-A22 Drill?
If the battery of your Hilti Drill does not engage with an audible double click, the retaining lugs on the battery might be dirty. Clean the retaining lugs and push the battery in until it engages.
Why does the battery on my Hilti SF 8M-A22 Drill run down so fast?
If the battery on your Hilti Drill runs down more quickly than usual, it might be due to a very low ambient temperature. Allow the battery to warm up slowly to room temperature.
How to unlock the on/off button on a Hilti Drill?
If the on/off button on your Hilti Drill cannot be pressed because it's locked, the forward/reverse switch is likely in the middle position. Push the forward/reverse switch to the left or right.
Defines signal words and symbols for hazards.
Critical safety advice for all power tool operations.
Precautions to ensure operator safety during use.
Safety related to the operating environment and power supply.
Specific safety instructions for drilling operations.
Safe handling and maintenance of Li-ion batteries.
Identifies and describes all parts of the tool.
Technical details of the drill/driver.
How to clean and maintain Li-ion batteries.
To Next Page
General
