What to do if my Hilti SFH 14-A Drill does not work and one LED flashes?
If your Hilti Drill doesn't work and one LED flashes, it could be due to a low battery. In this case, replace the battery and charge the depleted one. Alternatively, the battery might be too hot or too cold. Ensure the battery is within the recommended operating temperature range.
What to do if my Hilti SFH 14-A Drill doesn’t work and all four LEDs blink?
If your Hilti Drill doesn't work and all four LEDs are blinking, it's possible the tool was briefly overloaded. To resolve this, release the control switch and then press it again. Another possibility is that the overheating cut-out has been activated. In this case, allow the power tool to cool down and clean the air vents.
How to unlock the on/off button on a Hilti Drill?
If the on/off button of your Hilti Drill is locked and cannot be pressed, the forward/reverse selector switch is likely in the middle position. To unlock it, push the forward/reverse switch to the left or right.
What to do if the Hilti Drill battery does not engage with a click?
If the battery of your Hilti Drill does not engage with an audible double click, it might be because the retaining lugs on the battery are dirty. Clean the retaining lugs and push the battery in until it engages. If the problem persists, contact Hilti Service.
Why is there no hammering action on my Hilti Drill?
If there is no hammering action with your Hilti Drill, the operating mode is not set correctly at the selector ring. Set the selector ring to the “Hammer drilling” position.
General| Type | Cordless Hammer Drill |
|---|---|
| Voltage | 14.4 V |
| Battery Type | Li-ion |
| Chuck Size | 13 mm |
| Chuck Type | Keyless |
| Chuck Clamping Range | 1.5 - 13 mm |
| Max Torque | 40 Nm |
| Weight | 1.7 kg (with battery) |
| Speed | 2 speed settings |
To Next Page
