Hilti SID 2-A - Technical Data

22 English 2081236
*2081236*
3.3 Charge state display
The charge state of the Liion battery is displayed after pressing one of the
release buttons lightly (press only until slight resistance is felt).
Status Meaning
4 LEDs light. Charge state: 75 % to 100 %
3 LEDs light. Charge state: 50 % to 75 %
2 LEDs light. Charge state: 25 % to 50 %
1 LED lights. Charge state: 10 % to 25 %
1 LED blinks. Charge state: < 10 %
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
3.4 Items supplied
Impact screwdriver, operating instructions.
Other system products approved for use with this product can be found
at your local Hilti Store or at: www.hilti.group.
4 Technical data
4.1 Technical data
SID 2A
Rated voltage
10.8 V
Weight in accordance with EPTA procedure 01
1.1 kg
Rated speed under no load
0 /min …
2,500 /min
4.2 Battery
Battery operating voltage
10.8 V
Ambient temperature for operation
−17 ℃ … 60 ℃
(1 ℉ … 140 ℉)
Storage temperature
−20 ℃ … 40 ℃
(−4 ℉ … 104 ℉)
Battery charging starting temperature
−10 ℃ … 45 ℃
(14 ℉ … 113 ℉)
4.3 Noise information and vibration values in accordance with EN
62841
The sound pressure and vibration values given in these instructions were
measured in accordance with a standardized test and can be used to
Printed: 10.07.2019 | Doc-Nr: PUB / 5206085 / 000 / 04