Hilti SIW 22T-A 0.5 Inch - Intended Use

8 English
@
3/4" square drive with through hole
;
Forward / reverse selector switch with
safety lock
=
Control switch
%
Light to illuminate the work area
&
Belt hook (optional)
(
Battery
)
State-of-charge and fault display (Li-ion
battery)
+
Release button with additional function
(state-of-charge display activation)
3.2 Intended use
The product described is a hand-held cordless impact screwdriver. It is designed for tightening and releasing
nuts, bolts, anchors and wood screws.
The impact screwdriver may be used only for applications that do not require a precise/specified torque.
Failure to observe this point presents a risk of over-tightening and damage to the bolt, screw or workpiece.
▶ Use only Hilti lithiumion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Items supplied
Impact screwdriver/wrench, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by us for use with the product can be found at your
local Hilti Center or online at: www.hilti.group
4 Technical data
SIW 22TA
1
/
2
SIW 22TA
3
/
4
Rated voltage
21.6 V 21.6 V
Weight in accordance with EPTA procedure 01
3.2 kg 3 kg
Rated speed under no load
0 /min …2,000 /min
0 /min …2,000 /min
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
SIW 22TA
1
/
2
SIW 22TA
3
/
4
Sound power level, L
WA
108 dB 111 dB
Uncertainty for the sound power level, K
WA
3 dB 3 dB
Sound pressure level, L
pA
97 dB 100 dB
Uncertainty for the sound pressure level, K
pA
3 dB 3 dB
Printed: 05.04.2018 | Doc-Nr: PUB / 5136064 / 000 / 05