What to do if the drill bit cannot be released from Hilti TE 2?
If the drill bit cannot be released from your Hilti Drill, ensure that you pull the tool lock back as far as it will go and then remove the tool.
Why doesn't my Hilti TE 2 achieve full power?
If your Hilti Drill is not achieving full power, first ensure that the control switch is fully pressed. If the issue persists, check that the function selector switch isn't set to “Light hammering action”; if it is, set it to the “Hammer drilling” position. Finally, verify that the extension cord has an adequate conductor cross section.
What to do if Hilti TE 2 bit cannot be released?
If you're having trouble releasing the drill bit from your Hilti Drill, make sure that the chuck is pulled back as far as it will go. Then, try removing the tool.
How to troubleshoot no hammering action on a Hilti TE 2?
If your Hilti Drill has no hammering action, it may be too cold. Try bringing the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. Repeat if necessary, until the hammering mechanism begins to operate. Also, make sure that the function selector switch is set to the “Hammer drilling” position, and not “Rotary drilling only”.
What to do if Hilti TE 2 doesn't start?
If your Hilti Drill isn't starting, the issue might be with the electric supply. Try plugging in another electric tool or appliance to check if the outlet is working.
Why Hilti TE 2 Drill doesn't achieve full power?
If your Hilti drill isn't reaching full power, consider these possibilities: 1. Ensure the control switch is fully pressed down. 2. Verify that the function selector switch is set to the “Hammer drilling” position and not “Light hammering action”. 3. Check that you're using an extension cord with an adequate conductor cross section.
What to do if Hilti TE 2 bit makes no progress?
If the drill bit on your Hilti drill isn't making any progress, check to see if the power tool has been set to reverse rotation. If it is, set the power tool to forward rotation.
How to fix no hammering action on Hilti Drill?
If your Hilti Drill has no hammering action, here are a couple of things to check: * First, the power tool might be too cold. Bring the tip of the drill bit into contact with the working surface, switch the rotary hammer on and allow it to run. If necessary, repeat the procedure until the hammering mechanism begins to operate. * Second, make sure the function selector switch is set to the “Hammer drilling” position, not “Rotary drilling only”.
General| Power | 650 W |
|---|---|
| Weight | 2.7 kg |
| Rated input voltage | 230 V |
| Single impact energy | 1.8 J |
| Drilling diameter in steel | 13 mm |
| Triaxial vibration for hammer drilling into concrete | 13.5 m/s² |
| Dust removal module | Optional |
| Functions | Hammer drilling, Drilling |
| Chuck Type | SDS-Plus |
| Hammering speed | 4600 bpm |
| Impact Rate | 0-5000 bpm |
To Next Page
