Hilti TE 25 Rotary Hammer Drill
Technical data
Input power: 830 W
Voltage (versions): 100 V 110 V 120 V 220 V 230 V 240 V
Input current: 8.7 A 7.9 A 7.2 A 3.9 A 3.8 A 3.6 A
Frequency: 50–60 Hz
Machine weight: 4,9 kg
Speed under load: 1
st
speed 0–310 r.p.m.
2
nd
speed 0–640 r.p.m.
Hammering under load: 0–3720 blows/min.
Single impact energy: 3.8 Joule
Drill bits for concrete: 5–38.5 mm dia.
Recommended diameter range: 12–20 mm dia.
Drilling performace in medium-grade
concrete: 16 mm dia. = 60 cm
3
/min. = 300 mm/min.
TE-CX/C drill bit 5–17.5 mm dia.
TE-C-S drill bit 8–28 mm dia.
TE-C-GB drill bit 30–38.5 mm (1
1
/
2
″)
TE-C-BK percussion core bit 66–90 mm dia.
TE-C-HB bit for concrete forms 10–35 mm dia.
Chuck type: TE-C
Automatic cut-out brushes
Double insulation, class II, CENELEC EN 50144
Radio and T.V. interference suppression as per EN 55014
Slip clutch for protection against overloading and accidents
Dust-tight enclosure; permanent lubrication (maintenance free)
Variable speed control switch
Ajustable side handle with depth gauge
Typically the A-weighted nois levels of the tool are:
– sound pressure level: 89 dB (A)
– sound power level: 102 dB (A)
Wear ear protection.
The typical weighted acceleration is 11 m/s
2
.
Right of technical modifications reserved
Do not use this product in any way other than as directed by these operating in-
structions.
The respective regulations of your trade association and the enclosed safet precau-
tions must be observed.
The operating instructions should always be kept with the machine!
EG declaration of conformity
Designation: Rotary Hammer
Serial numbers: XX/0000001-9999999/XX
Model/type: TE 25
Year of design:1996
We declare under our sole responsibility
that this product is in conformity with the fol-
lowing standards or standardisation docu-
ments:
EN 50144, EN 55014 or EN 55011, EN
60555 according to the provisions of the
directives 73/23/EEC, 89/336/EEC,
89/392/EEC
Hilti Corporation
Martin A.C. Messner Dr. Heinrich Schäperkötter
Vice President D&ET Division Development Manager D&ET Division
11/1996 11/1996
1
2
3
4
5
To Next Page
