Handlebar Adjustment
Adjust the handlebar of the bicycle
Please adjust the handlebar of the bicycle as follows:
The brake is used not only to stop the bicycle but also to control the speed. The maximum
braking force of the tires refers to the stress when the tires are “locked” (do not rotate) and
slide. In case of tire slip, most braking force will be lost and the bicycle will be out of control.
Please brake gently and stop the bicycle slowly, namely progressive braking skill, to
prevent the tires from being locked.
The light is powered on by built-in batteries. Please ensure the batteries are fully charged
while riding at night.
Turn on or turn off the light as follows:
Turn on the switch of the front light.
Turn on the light even in the day so that it is easier for other road users to identify the
bicycle.
Push the brake to the handlebar to increase the braking force gradually.
If the wheels are stuck, please release the brake so that the wheels can rotate and are
not stuck.
Open the front cover on the stem.
Put on the handlebar and adjust the angle properly.
Lock the front cover on the stem.
The batteries may explode if a wrong charger is used and consequently
severe injury or death may be caused.
Only the charger attached can be used.
Read and comply with the instructions in the charger specification.
The batteries should be charged at a temperature of 10-30℃.
Please charge the batteries as follows:
Take out the batteries.
Ensure no damage of battery case and other visible damages.
Please charge the batteries on the surface of non-flammable objects,
e.g.: ceramics.
Comply with the instructions in the charger specification (if contained).
Insert the charger plug into the socket on the batteries.
Insert the charger plug into a 230V and 50Hz power socket and the light on the charger
will be red. It takes 5-6 hours to charge the batteries. When the light turns green, it
means that the batteries have been fully charged.
Remove the plug from the socket.
Remove the plug from the battery socket.
Reinstall the batteries.
The user can identify the permissible inflation pressure range on the side wall of the tires.
Test inflation pressure of the tires.
Foot pump with pressure gage/pressure meter is recommended to inspect and correct tire
pressure.
Battery Charging
Warning
Tire Pressure Inspection
Bicycle Control
Brake
Light ON/OFF
Speed Change
To speed up, start with a lower gear at the beginning, and change to a higher gear as the speed
increases.
The speed will decrease when going uphill. Lower the gear to maintain a certain pedaling force
The speed will increase when it is downwind, Increase the gear to maintain a certain pedaling
force
①: Toggle it to downshift, making it slower and more labor-saving
②: Toggle it to uplift, making it faster and more laborious
Laborious
Effortless
Slow
Fast
To Next Page
Loading...
