Fax
Purchase date
Bicycle name
Frame number
Wheel size
Color
Full name
Address
Post code
Ensure the inflating volume of the tires is limited to the recommended value indicated
on the side wall of the tires.
Ensure the tires have patterns and are free from bulge or excess wear.
Ensure the rims run normally and do not waggle or bend obviously.
Ensure all wheel spokes are secure and not broken.
Inspect whether the nut of the spindle is tightened. If the bicycle has a quick release
spindle, please ensure the locking lever is fastened and at OFF position.
While inflating the tires, please be sure to check the tire pressure.
Please charge the batteries for 6-10 hours when the battery level decreases to
30%-50% in order to extend the service life. If stored at a low battery level, the
batteries will be exhausted and cannot be reused. Please charge the battery pack
fully after long-distance riding. Please do not charge the batteries for a long time
(namely “more than 10 hours”) in summer in order to avoid damage.
The batteries should be charged monthly during storage.
The charging temperature should be 0-45℃.
The battery pack may not be fully charged if the temperature is too high or too low.
The temperature may rise slightly when the batteries are charged, but it should be
limited to 50℃. If the indicator light of the charger remains unchanged or the
batteries are very hot (the temperature is above 50℃) after the batteries are fully
charged, please consult the seller about maintenance immediately.
After the batteries are removed from the bicycle, try to reduce vibration and
disturbance in order to avoid damage. Keep the charger far away from water.
Every battery pack is designed with a charger. Please do not charge the battery
pack using other types of charger in order to avoid burn-out of batteries and
danger thus incurred.
The batteries should be stored at a temperature of 0-45℃ in a clean, cool, dry and
well-ventilated place. The batteries should be protected from sunlight, fire, flood
and corrosive substance during transportation and storage.
Please keep the button at the head of the battery holder at “ON” during charging.
Please ensure no short circuit of the socket in the wall in order to avoid burn-out of
batteries and danger thus incurred.
Please do not pull out the power key while riding at high speed.
Wheel Set Damage and Wear
Description of Battery Maintenance and Charging
Inflation Pressure
Parts and Accessories List
All specifications will be attached to the bicycle.
Please pull the pedal outward and fold it downward before storage or transportation.
(The movement direction of the pedal is shown below)
Attention: Please do not raise the seat post above the minimum insertion line
indicated on the seat post.
Pedal
Seat post
Bicycle Card
Telephone/mo-
bile number
Special function/ac-
cessories
To Next Page
Loading...
